BOND AMERICA

Updated 1060 days ago
  • ID: 5654225/92
Use the non-skid mat on any flat surface, but be sure not to pull down on the hem as you set up. Or, if you want to use the clamps, be sure to use a flat surface with a "true" bottom, similar to a piece of hardwood board. One of the long pre-cut shelves available at hardware stores and home centers is a good choice. I can't stress enough that it is very very important to have your machine on a perfectly flat surface... Be sure not to screw the clamps on too tightly. This could raise the back of the bed and cause the needles to go out of alignment... Be sure there are no raised retainer bars across the bed. These are the green bars that hold in the needles. If any are raised slightly you can push them down with your finger or use a small hammer with fabric or rubber as protection to tap them down into place.
  • 0
  • 0
Interest Score
1
HIT Score
0.00
Domain
bond-america.com

Actual
bond-america.blogspot.co.uk

IP
184.168.221.19

Status
OK

Category
Other

Similar Profiles


  1. DEDHAM CONCRETE CUTTING - dedhamconcretecutting.com
  2. AEGO - aego.us
  3. GEORGETOWN CONCRETE CUTTING - georgetownconcretecutting.com
  4. PETER CURRAN - wirralfrenchpolishing.co.uk
  5. TRIKLEENER - trikleener.com
0 comments Add a comment